Vertical Height Total: 24mm or more
12mm 12mm
Lab receives impression from doctor and begins making…
• Master model • Verification jig • Baseplate/bite rim
Appointment #1
• Remove healing caps off the Transmucosal abutments • Place verification jig into the transmucosal abutments • Make sure all prosthetic screws are seated • Verify fit of the jig • If the jig does not fit correctly follow instructions sent with jig • Verify proper placement with X-ray * Follow directions sent with jig • Remove the jig • Use baseplate/bite rim to register the vertical • Record Alameter and Papillameter • Mark high smile line • Mark mid-line • Take photos (see photo guide video) • Remove baseplate/bite rim and send back
Photo Guide Video
• Upload pictures to website portal • Place Transmucosal healing caps • Do Not Remove Transmucosal Abutments
After lab received the doctor information, the lab will...
• Articulate models • Set teeth for try-in
Appointment #2
• Remove healing caps off the Transmucosal abutments • Place try-in • Verify tooth position, smile line, vertical dimension and phonetics • Place Transmucosal healing caps • Do Not Remove Transmucosal Abutments
After lab receives the doctor information, the lab will… • Evaluate Rx and see if any changes are needed • Fabricate Implant Bar • Set teeth
Appointment #3
• Remove healing caps off the Transmucosal abutments • Seat Implant Bar • Verify tooth position, smileline, vertical dimention and phonetics
• Return everything to the lab for processing • Do Not Remove Transmucosal Abutments
After lab receives the doctor information, the lab will… • Process the set-up • Place final attachment gaskets
Appointment #4
• Deliver final product • Instruct patient on the use and care of the appliance
35
Powered by FlippingBook